5715K17 #01B371

1 1/2HP, single-phase, 1725 RPM.

Up to 11.11 cfm with 3 HP motor. Cast iron cylinders. Reliable workhorse found on most contractor models. Shipped w/ 11.5" steel flywheel, aftercooler and air filter assby. Footprint is 7.08" x 5.19". Does NOT ship with oil. Please note that a model...

Up to 11.11 cfm with 3 HP motor. Cast iron cylinders. Reliable workhorse found on most contractor models. Save money by using your old flywheel and aftercooler. Includes air filter. Footprint is 7.08" x 5.19". Does NOT ship with oil. Please note that a...

If your crank is grooved, replace it to ensure that your rebuild will not be in vain. If there are only surface deposits of aluminum from the bearings, then remove them with a soft wire brush and then polish your crank.

Old Part Numbers: K17REPKIT/10, K17REPKIT/30, K17REPKIT/SYNIncludes most needed parts for a full rebuild. Kit contains: Gasket Set, Oil Sight Glass, Oil Breather/Dipstick, Rings, Air Filter, Reed Valves and Blended Synthetic Compressor Oil (order 2 pair...

11" diameter with a tapered bore

Replace these if bent or worn. Check crank for damage first. (includes upper bushing)

1/4" Male NPT with unloader

Did your unit tip over and break the head. Replace it with a new one. Order gaskets too.

Old Part Numbers: WLS30-SEAL, WLS30, WLS30SEALFully pneumatic wheel assby w/sealant. Just slide onto axle.